Tile

1. Verify tub is level and square, adjust as needed.

2. Verify the wall sheeting and waterproof membrane is correctly installed.

3. Install a starter board above the tub rim along the side of the tub to start the first section of tile.

4. Using a trowel recommended for the tile size, apply thinset above the starting board.

5. Install tile checking square and level while using spacers.

6. Continue with thinset and tile until the entire wall is covered. At the corners, place tile close to the corner while leaving some room for expansion.

7. Continue tile to the ceiling.

8. ​Move to the end walls, continue above steps.

9. Place final row of tile at the tub lip to complete the tile installation.

10. After the required drying time, grout tile except for corners and tub lip.

11. Use matching color silicone caulking at the wall corners and tub lip.

12. Once the required drying time is complete, seal the grout, two coats.